
Start with what the bathroom was built for
Bathrooms here usually follow one of two arrangements. In the first, an instant heater hangs on the shower wall and heats the water as it passes. In the second, a storage tank, often out of sight above the bathroom ceiling behind an access panel, feeds hot pipes to the shower mixer and the basin. What you have decides what you can buy. Like for like is the short job. Changing type is not.
This page is for a tenant whose shower has gone cold, a landlord whose tank has leaked between tenancies, or a house owner whose upstairs shower keeps cutting out. For that landlord in one of the 2000s Kiaramas condominiums on Jalan Desa Kiara (Sutera, Ayuria, Danai), the heater may already have been replaced once, and the point feeding it may be as old as the building.
Instant and storage heaters compared
| Instant heater | Storage heater | |
|---|---|---|
| What it serves | Usually one shower | Several outlets through hot pipes, usually the shower and basin |
| What must be there already | A cold supply with a stop valve, and a protected power point | Hot pipework in the walls, mixer taps, a protected power point, and a way to reach the tank |
| Water pressure | Needs enough flow to switch on. Some models have a built-in pump. | Delivers at the pressure the building supplies |
Heaters fitted here are electric. Gas is outside what this business takes on.
The power point and its protection
A water heater puts mains electricity beside running water, so the supply matters more than the heater. It needs its own switch and earth-leakage protection, the device that cuts the power when current escapes to earth.
Photos of the heater switch and the distribution board, cover closed, give a first answer on whether the existing supply suits the heater you picked. The point is checked again on the day, and if it does not suit you are told before anything is fitted.
Both halves of this job are regulated in Malaysia. Suruhanjaya Tenaga registers electrical contractors and competent persons, and SPAN issues permits for work on water-supply pipes. Ask who will do each half and what registration or permit they hold. A heater that calls for a new point, a new circuit or work at the distribution board is identified before any quote.
Water pressure on high floors
Mont Kiara is nearly all towers, so pressure is worth a question. In a building fed by gravity from a roof tank, the floors nearest the tank usually have the weakest pressure, unless the building runs a booster pump for them. An instant heater needs a minimum flow before it switches on, so on a weak supply it may cut in and out. A model with a built-in pump often helps, but a pump cannot deliver more water than the pipe brings. Send a short video of the shower running cold at full flow, and ask your management office how your floor is supplied.
Water pressure in a house
A house raises the same question for a different reason. Many terrace, semi-detached and detached houses are fed from a tank in the roof space, and the water falls to the taps by gravity. The bathroom upstairs sits closest to that tank, so its pressure is often the lowest in the house. An instant heater or a rain shower there may need a model with a built-in pump. Say whether the bathroom is upstairs or down, and send the same video of the shower running cold. The tank itself is not worked on.
What to decide before you buy
- The type: the same as the bathroom has now, unless a change has been agreed first.
- The wattage. Send the box label before you open the box.
- For an instant heater: pump or no pump.
- For a storage heater: capacity in litres, and vertical or horizontal mounting to match the space.
How the visit goes
Isolate
Power to the heater is switched off and tested. The water is closed at the stop valve.
Old heater off
A storage tank is drained to the floor trap first. The old heater is disconnected and taken down.
Fix the new one
Old holes are reused where they line up. New holes in tile are drilled slowly with a tile bit, after a detector has gone over the wall: bathroom walls carry concealed pipes, and in a strata building the by-laws bar drilling within 300 mm of them, so the detector decides where the fixings can go.
Connect
The water connections are made with new hoses and seals, then the electrical connection.
Test
Joints are watched under pressure for drips. The earth-leakage test button is pressed to confirm it trips. Then you run the shower yourself.
What can stop the job
- An access panel too small for the new tank to pass. Opening the ceiling is more work, and the management decides whether it needs written approval.
- A stop valve that is seized or corroded. It is replaced first, and that is work on a water-supply fitting.
- Too little flow for the model you bought, or no power point that suits it.
What moves the cost
The type and size of heater. Like for like, or a change of type. Whether the point suits it. How the tank is reached, if it is above the ceiling. The state of the valve and hoses. Other bathroom work can go on the same list: a dripping mixer or a leaking hose, or fresh silicone and other small repairs.
Questions about water heaters
Does a water heater need its own power point?
Yes. A heater should have its own switched supply with earth-leakage protection, and the cable and breaker behind it have to suit the heater's wattage. If the bathroom has no such point, or the one there does not suit the new heater, the job becomes new wiring, and you are told so first.
The breaker trips whenever the water heater is switched on. What does that point to?
Most often to current leaking to earth, and the device that tripped is doing its job. A heating element near the end of its life, water inside the casing or a damaged cable can each cause it. Leave the heater switched off and do not keep resetting the breaker. Send a photo of the heater, its switch and the distribution board.
My storage heater has failed. Can an instant heater go in its place?
It can, for the shower only, and only if the shower wall has a protected power point. Where it has none, that is new wiring, and you are told before any quote. A storage tank usually feeds hot pipes to the shower mixer and the basin. An instant heater usually serves one shower, so the other hot taps run cold afterwards. The shower mixer may need changing as well, because it was piped for a separate hot supply.